I seem to have finished knitting hats, and only hats (ok, except for one pair of gift socks), since November. Eight hats in five months, two of which you can find here, one here (which I knit twice), one more here, and the remaining three in this post.
Happily, all the plain stockinette that’s involved in knitting a Sockhead Slouch Hat (designed by Kelly McClure) is totally worth it, because I adore the finished product. The colors are my favorite, the speckles make me happy, the ribbing is super cozy, and the length is just right for a good amount of slouch. I modified a few things in my version: I used a sport-weight yarn (BMFA Socks That Rock Mediumweight), cast on fewer stitches (136), and knit to a shorter length (10.5″ total) before the crown decreases. This removed some slouch and is just right for my head. I will update my project page with measurements later, as I did not get a chance to do so yet.
Because I COULD NOT RESIST, I knit a wee baby hat for Hatchling so that we could be all matchy-matchy. I really should have done longer ribbing for the rolled-up brim, but alas I did not. I used the same yarn and needles (2.75 mm) and cast on 88 stitches in a gauge of 7 sts/inch, for a hat that should be approximately 12.5″ around after blocking, unstretched. Newborn heads are typically 13″ or so, but with the stretchiness of the fabric and the fact that I can roll the brim down as the kid grows, I’m hoping the hat will continue to fit for a while, because that little i-cord loop at the top is just too damn precious.
I had intended to make this hat (Fidra, designed by Gudrun Johnston) for my friend’s December birthday. However, it’s March, and it’s still sitting in my house. It went through a failed iteration with inappropriate yarn, and then waited weeks for a pom-pom, and now I just haven’t gotten around to mailing it. Despite that, the finished product is pretty fabulous. Knit with the called-for yarn (BT Quarry) and needles, it’s actually a little snug, so I hope she likes it as I know she likes her hats on the bigger side. If you’re finding the Quarry yarn difficult to work with (it’s basically unplied pencil roving) I’d recommend going up a needle size or using metal instead of bamboo. Going up a size would give everything a bit more room to move around and the size would probably still work out fine.
So there are my hats! Sorry none of them are modeled, I haven’t had time for proper photoshoots lately. When the kiddo arrives I’ll be sure to take a mommy-and-me shot in matching hats, middle-of-summer heat waves be damned. 😉